The GoLogic™ lead set connectors (provided with the GoLogic) are normally pushed directly onto 25 mil (0.10") header pins. If no header pins are available, then our gripper probes allow you to connect to individual pins on a chip...

a
A. MicroClip ($6.60 each) Large gripper probe, suitable for 0.05 inch (1.27 mm) pitch pins	B. NanoClip ($8.60 each) Small gripper probe, suitable for 0.012 inch (0.3 mm) pitch pins

All prices in US dollars. Shipping and taxes not included. Price and specifications subject to change without notice. GoLogic™ sold separately.

The best probing solution is integrating female Mictor™ connectors into your design. This eliminates the need to connect individual lead set wires to individual pins on your device. Instead, the Mictor™ cable is connected to your test port.

Add one or two female Mictor™ sockets (part # NCI-R1-38) to your design and route your target signals to the pins. The male Mictor™ cables (both 14-inch and 4-inch models are shown below) attach to the female Mictor™ sockets on your device.

36-channel GoLogic™ Mictor™ cable

$375 each

All prices in US dollars. Shipping and taxes not included. Price and specifications subject to change without notice. GoLogic™ sold separately.

• The standard length Mictor™ cable is 14-inches long. A 4-inch low-capacitance Mictor™ cable is also available for fast, low-voltage signals.
• Two GoLogic™ Mictor™ cables are required for 72 channels.
• GoLogic™ Mictor™ cables are pin-compatible with female sockets sockets intended for use with Agilent®/Tektronix® logic analyzers. However, the GoLogic™ cables cannot be used by other logic analyzers.